ABB CRB 15000 - General Procedures; Mounting Instructions for Sealings

5.2 General procedures
5.2.1 Mounting instructions for sealings
General
This section describes how to mount different types of sealings.
Equipment
NoteArticle numberConsumable
Shell Gadus S23HAC042536-001Grease
Rotating sealings
The following procedures describe how to fit rotating sealings.
CAUTION
Please observe the following before commencing any assembly of sealings:
• Protect the sealing during transport and mounting, especially the main lip
on radial sealings.
• Keep the sealing in its original wrappings or protect it well before actual
mounting.
• The fitting of sealings and gears must be carried out on clean workbenches.
• Use a protective sleeve for the main lip during mounting, when sliding over
threads, keyways or other sharp edges.
Radial sealings
A radial sealing consists of a flexible rubber lip bonded to a rigid metal case. Only
one side of the sealing is static with a metal insert.
xx2300000433
NoteAction
Check the sealing to ensure that:
• The sealing is of the correct type.
• There is no damage on the main lip.
1
Continues on next page
202 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.2.1 Mounting instructions for sealings