NoteAction
xx2000002168
Remove the lifting aid by removing the screws.10
Clean pushed-out flange sealant, if any.11
Connecting the axis-6 joint unit cabling
NoteAction
xx2000002164
Reconnect the connectors to the drive board.
• D6.X1 to X1
• D6.DC+ to +DC
• D6.DC- to Ground
• D6.X4 to X4
• D6.X2 to X2
• D6.X5 to X5
1
xx2000002163
Connect the connectors to each other and snap
them to the cable holders.
• J7.CS to J7.CS
• J7.CP to J7.CP
2
Continues on next page
1014 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.6.7 Replacing the axis-5 joint unit and the axis-5 to axis-6 transition cabling
Continued
To Next Page
Loading...
