Section D Graphic Display
D-78
D 7.4.2 Undo
→Edit → Undo
→CTRL+Z
This is a one-level function and undoes the last change made to the graphic object.
D 7.4.3 Repeat
→Edit → Repeat
→F8
The last action can be repeated, e.g. deleting the end point of a polyline or drawing graphic
objects of the same type one after the other, without having to select the type again under Draw.
D 7.4.4 Select single object
→Click graphic object.
→Edit → Select single object,
→Position cursor (with arrow keys) on graphic object,
→Select with S
PACEBAR.
If several graphic objects have been selected and one wants to select a single one of
these, then click on the free draw area with the left mouse button (all graphic objects will
be deselected) and proceed as above.
Every graphic object selected is marked by a frame.
D 7.4.5 Select all
→Sweep over the whole drawing area with the left mouse button pressed.
→Edit → Select all.
All graphic objects in the drawing area are displayed with their frames. Alterations of the attributes
effect all graphic objects selected.
Gross Automation, 1725 South Johnson Road, New Berlin, WI 53146, www.ssacsales.com, 800-349-5827
To Next Page
Loading...