NoteArt. no.Spare part
Used with protection type Hy-
gienic.
3HAC078798-001Gasket, axis 6, Hygienic
Replace if damaged.
Used with protection type Hy-
gienic.
3HAC079688-001Seal ring unit
Replace if damaged.
The seal ring unit is wear part.
Used with protection type Hy-
gienic.
3HAC034160-003Sealing washer
Replace if damaged.
Required tools and equipment
NoteArticle numberEquipment, etc.
Content is defined in section Standard
toolkit on page 890.
-Standard toolkit
Used with robots in protection type
Hygienic
Used for loosen and tighten the seal
ring unit on tool flange of the Hygienic
robots.
3HAC079686-001Flange tightening tool
Used with robots in protection type
Hygienic
3HAC079684-001Guide pin for stainless shaft
on tool flange
Required consumables
NoteArt. no.Consumable
Molykote P19003HAC070875-001Grease
For robots with protection type
Hygienic
CAUTION
Always cut the paint with a knife and grind the paint edge when disassembling
parts. See Cut the paint or surface on the robot before replacing parts on page 158.
Replacing the sealing parts on tool flange of Hygienic robots
NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
1
Continues on next page
Product manual - IRB 1200 145
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
3 Maintenance
3.4.2 Replacing the sealing set on tool flange of Hygienic robots
Continued
To Next Page
Loading...
