NoteAction
Flange tightening tool:
3HAC079686-001
Place the flange tightening tool together with a
3/8" (10 mm) socket spanner on the seal ring unit
and tighten the unit.
10
Tightening torque: 6 Nm
xx2100001456
Guide pin for stainless shaft on tool
flange: 3HAC079684-001
xx2100001457
Fit two guide pins to the tool flange.11
xx2100001458
Place the stainless shaft on the tool flange with
guidance of the two guide pins.
Make sure the pin hole on the shaft aligned with
the pin on the tool flange.
12
Tightening torque: 1.5 Nm
xx2100001459
Secure with screws and washers.13
Continues on next page
Product manual - IRB 1200 791
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.6.9 Replacing the axis-5 and axis-6 drive unit
Continued
To Next Page
Loading...
