ABB IRB 1200 - Page 88

Note
The two M4 thread holes shown in the following figure are used for fitting the
cable harness or air hoses of the tools rather than fitting extra equipment.
2xM4 10
xx2100001280
Lower arm
568,1
666,1
30 ±0,15
2 x M5
7.5
A
A
IRB 1200-7/0.7
IRB 1200-5/0.9
122,5 122,5
122,5 122,5
xx1300000382
Continues on next page
88 Product manual - IRB 1200
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
2 Installation and commissioning
2.3.7.2 Holes for fitting extra equipment
Continued