Note
A fan is recommended to be used to avoid overheating of motor and gear in
applications with intensive motion (high average torque and/or short wait time)
of axes 1 and 2. IP54 is valid for cooling fan.
A fan is also recommended to be used if the environmental temperature is high.
How to install a fan is described in section Installation of cooling fan for motors
(option) on page 93.
Refitting motors
Use this procedure to refit motors axes 1, 2, 3, 4, 5 and 6.
Note
How to refit motors axes 5 and 6 on IRB 2600ID is described in sections:
• Replacing motor axis 5 - IRB 2600ID on page 329
• Replacing motor axis 6 and wrist unit - IRB 2600ID on page 341.
Note
The procedure contains information how to refit motors on all axes of the robot.
Some steps are only applicable to a certain motor. Follow the steps carefully in
order not to miss vital information!
InformationAction
See Refitting motors on page 313.
• Preparations before the refitting
of motors on page 320
Note
Before starting the refitting of the motor, first
make the necessary preparations!
1
Note
Whenever parting/mating motor and gearbox,
the gears may be damaged if excessive force
is used!
2
Place the motor carefully in the gearbox.3
Make sure that:
• the motor is turned the correct
way
• the pinion or gear of the motor
does not get damaged!
Fit the motor, making sure the motor pinion is
properly mated to the gear in the gearbox.
4
Continues on next page
322 Product manual - IRB 2600
3HAC035504-001 Revision: Q
© Copyright 2009-2018 ABB. All rights reserved.
4 Repair
4.7.2 Refitting motors
Continued
To Next Page
Loading...
