ABB IRB 2600 Series - Lifting and Turning a Suspended Mounted Robot

2.3.2 Lifting and turning a suspended mounted robot
Validity of this section
This section is only valid for IRB 2600-20/1.65, IRB 2600-12/1.65, IRB 2600-12/1.85,
IRB 2600ID-15/1.85, IRB 2600ID-8/2.0.
Introduction
How to lift and turn the robot to a suspended position using the turning accessory
is described in the lifting instruction delivered with the turning accessory. Article
numbers for the accessory and the instruction is specified in Special tools on
page 442. Any additional equipment required is specified in the instruction for the
lifting accessory. Contact ABB for more information.
How to lift and turn the robot into position for wall position: Contact ABB for more
information.
How to lift and turn the robot into position for tilted position: Contact ABB for more
information.
Illustration
xx1500002117
Product manual - IRB 2600 63
3HAC035504-001 Revision: Q
© Copyright 2009-2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.2 Lifting and turning a suspended mounted robot