ABB IRB 2600 Series - Page 351

Concluding procedure
InformationAction
Pendulum Calibration is described in Op-
erating manual - Calibration Pendulum,
enclosed with the calibration tools.
Recalibrate the robot.1
Axis Calibration is described in Calibrating
with Axis Calibration method on page 403.
General calibration information is included
in section Calibration on page 391.
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on page 28.
2
Product manual - IRB 2600 351
3HAC035504-001 Revision: Q
© Copyright 2009-2018 ABB. All rights reserved.
4 Repair
4.7.4 Replacing motor axis 6 and wrist unit - IRB 2600ID
Continued