Cooling fan
The details of the cooling fan are shown in the figure below.
xx0900000137
FanboxA
Groove in the connectorB
Back plateC
Part of the fanbox that can be removed, if needed. NOTE! Only valid on motor
axis 1!
D
Required equipment
NoteArticle numberEquipment
For Spare part no. see chapter Spare
parts:
• Spare part lists on page 445
-Cooling fans axes 1 and 2
Loctite 243. Used for the three tightening
screws.
-Locking liquid
Content is defined in section Standard
tools on page 441.
-Standard toolkit
See chapter Circuit diagram on page 447.-Circuit diagram
These procedures include references to
the tools required.
Other tools and procedures
may be required. See refer-
ences to these procedures
in the step-by-step instruc-
tions below.
Continues on next page
94 Product manual - IRB 2600
3HAC035504-001 Revision: Q
© Copyright 2009-2018 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Installation of cooling fan for motors (option)
Continued
To Next Page
Loading...
