NoteAction
Brake release tool: 3HAC081310-
001
Release the brakes of the axis-1 motor with the
brake release tool.
1 Turn off the brake release tool.
2 Connect the tool to the R2.MP1 connector.
3 Release the brakes by turning on the brake
release tool and pressing the brake release
button on the tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
2
User instructions are enclosed with
the tool.
xx2100000666
Guide pin, M10x150: 3HAC15521-
2
Fit guide pins in opposite holes.3
xx2100002815
Put the motor on the tool shelf and rotate it into
position.
CAUTION
Risk of pinching! Do not pinch the motor cabling.
Route the cables throughout the motor connector
hole.
4
xx2100002809
Figure 5.1:
Raise the revolving handle to assemble motor.
• Make sure that the motor pinion is properly
mated to the gear in the gearbox.
• Make sure that the motor pinion does not
get damaged.
• Make sure that the direction of the cable
exit is facing the correct way.
5
Continues on next page
Product manual - IRB 5720 333
3HAC079195-001 Revision: A
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.8.1 Replacing the axis-1 motor
Continued
To Next Page
Loading...
