1.2.2 Safety symbols on controller labels
Introduction to safety symbols
Both the manipulator and the controller are marked with labels containing safety
symbols and important information about the product. The purpose of the labels
is to ensure personal safety for all personnel handling the robot, for example during
installation, service, or operation.
The safety symbols are language independent, they only use graphics. The
information labels contain information in text. See Symbols and information on
labels on page 20.
Note
The safety and information labels on the product must be observed.
Symbols and information on labels
Note
The descriptions in this section are generic, the labels can contain additional
information such as values.
DescriptionLabel
Read the user manual before use.
xx1400001152
The robot is delivered to start in automatic mode
xx2100000104
CE label
xx1800000835
Continues on next page
20 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
1 Safety
1.2.2 Safety symbols on controller labels
To Next Page
Loading...
