5.2.9 Replacing the main computer
Location
The illustration shows the location of the main computer in the controller.
xx1800000033
Note
To confirm whether this unit is available in your controller, see chapter Overview
of the controller on page 38.
If this unit is not available in your controller, ignore the related procedure to this
unit when you do any maintenance or repair work.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC063061-001Main computer module assembly
Required tools and equipment
Note
For robots with the controller delivered to start in automatic mode, a FlexPendant
is required after the replacement to be able to change to automatic mode.
Continues on next page
318 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.9 Replacing the main computer
To Next Page
Loading...
