8.4 Standard toolkit for controller
General
All service (repair, maintenance and installation) instructions contain lists of tools
required to perform the specified activity. All special tools, that is, all tools that are
not considered as standard tools as defined below, are listed in their instructions
respectively.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instructions.
Standard toolkit for controller
DescriptionTool
Tx10Screw driver, Torx
Tx20Screw driver, Torx
Tx25Screw driver, Torx
Tx25Ball tipped screw driver, Torx
4 mmScrew driver, flat blade
8 mmScrew driver, flat blade
12 mmScrew driver, flat blade
Phillips-1Screw driver
8 mmBox spanner
Toolkit recommended for troubleshooting
NoteTool
Contents as specified above.Normal shop tools
-Multimeter
To document problems or proceduresCamera
570 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
8 Reference information
8.4 Standard toolkit for controller
To Next Page
Loading...
