3.4.4 Replacing the controller from vertical mounting kit to19" rack mounting kit
General
If the 19" rack mounting kit and vertical mounting kit are purchased at the same
time, the controller will be mounted with vertical mounting kit when delivered to
the customer from ABB. The vertical mounting kit can be removed and replaced
with the 19" rack mounting kit.
Required equipment
InformationEquipment
3HAC063918-001Mounting kit
See Standard toolkit for controller on
page 570.
Standard toolkit
Removing the vertical mounting kit
Use this procedure to remove the vertical mounting kit from the controller.
Info/illustrationAction
xx1800000458
Support foot unit, 2 pcsA
Torx countersunk screw M4x10 (4
pcs)
Tightening torque: 1.7-1.8 Nm
B
Remove the screws.1
Remove the support foot units.2
Refit the screws.3
Continues on next page
68 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.4 Replacing the controller from vertical mounting kit to19" rack mounting kit
To Next Page
Loading...
