Info/illustrationAction
xx1800000381
Back hanging bracketA
Torx countersunk screw M4x10 (6
pcs)
Tightening torque: 1.7-1.8 Nm
B
Remove the screws.4
Remove the back hanging bracket.5
Refit the screws.6
xx1800000379
Side cover unitA
Torx counterink screw M4x16 (6
pcs)
Tightening torque: 1.7-1.8 Nm
B
Remove the screws.7
Remove the side cover unit.8
Refit the screws.9
Installing the 19" rack mounting kit
Use this procedure to install the controller in a 19" cabinet.
InformationAction
xx2100000137
Remove the screws on the front panel.1
Continues on next page
Product manual - OmniCore C30 69
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.4 Replacing the controller from vertical mounting kit to19" rack mounting kit
Continued
To Next Page
Loading...
