ABB OmniCore C30 - Replacing the Safety Digital Base Device

5.2.8 Replacing the safety digital base device
Location
The illustration shows the location of the safety digital base device in the controller.
X14 X15
MS
AS1/GS1
AS2/GS2
ES1
ES2 ESOUT1 ESOUT2
MON
AC
PS
PC
HMI
EP
I/O
X17
X45
X0
Q0
X4
X2
X3
X1
PC PWR
PC HDD
ABB Ability™
ETHERNET SWITCH
X18
WAN LAN MGMT
X19
X20
PC STAT
xx1800000032
Note
To confirm whether this unit is available in your controller, see chapter Overview
of the controller on page 38.
If this unit is not available in your controller, ignore the related procedure to this
unit when you do any maintenance or repair work.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
DSQC10423HAC062908-001DSQC1042 Extended safety
3HAC069538-001Connectors Safety I/O
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 570.
-Standard toolkit
-ESD protective wrist band
Continues on next page
Product manual - OmniCore C30 313
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.8 Replacing the safety digital base device