5.2.11 Replacing the power supply
Location
The illustration shows the location of the power supply in the controller.
xx1800000035
Power supply baselineA
Power supply optionalB
WARNING
Do not touch the power supply when the DC OK LED is on.
There is residual voltage in the power supply even if the main switch is in the
OFF position.
Note
To confirm whether this unit is available in your controller, see chapter Overview
of the controller on page 38.
If this unit is not available in your controller, ignore the related procedure to this
unit when you do any maintenance or repair work.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
Continues on next page
Product manual - OmniCore C30 365
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.11 Replacing the power supply
To Next Page
Loading...
