3.3 Transporting and handling
3.3.1 Unpacking
Unpacking the controller
Note
If the desktop mounting kit is mounted to the controller, do not hold the TPU
connector (X4) during any moving or transporting of the controller.
Action
Make a visual inspection of the packaging and make sure that nothing is damaged.1
Remove the packaging.2
Check for any visible transport damage.
Note
Stop unpacking and contact ABB if transport damage is found.
3
Clean the unit with a lint-free cloth, if necessary.4
Make sure that the lifting accessory used (if applicable) is suitable to handle the weight
of the controller.
5
If the controller is not installed directly, it must be stored as described in Transportation
and storage conditions on page 40.
6
Make sure that the expected operating environment of the controller conforms to the
specifications as described in Operating conditions on page 41.
7
The controller can be taken to its installation site as described in section On-site in-
stallation on page 57.
8
Product manual - OmniCore C30 55
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.3.1 Unpacking
To Next Page
Loading...
