3.4.3 Mounting the controller with vertical mounting kit [3002-2]
General
The OmniCore C30 controller is designed to fit with a vertical mounting kit.
xx1800000376
Note
The side with the fans should be downward when installing the controller in
vertical position.
Note
If the 19" rack mounting kit and vertical mounting kit are purchased at the same
time, the controller will be mounted with vertical mounting kit when delivered to
the customer from ABB. The 19" rack mounting kit will be delivered as a spare
part at the same time.
For detail information on replacing the vertical mounting kit to 19" rack mounting
kit, see Replacing the controller from vertical mounting kit to19" rack mounting
kit on page 68.
Required equipment
InformationEquipment
3HAC063920-001Mounting kit
See Standard toolkit for controller on
page 570.
Standard toolkit
Continues on next page
64 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the controller with vertical mounting kit [3002-2]
To Next Page
Loading...
