Installing the vertical mounting kit to the controller
Use this procedure to install the controller in vertical position.
Info/illustrationAction
xx1800000378
Remove the left side cover screws.
Note
The left side is the side without fans.
1
xx1800000379
Side cover unitA
Torx counterink screw M4x10 (6
pcs)
Tightening torque: 1.7-1.8 Nm
B
Install the side cover unit.2
xx1800000380
Remove the screws on the back.3
Continues on next page
Product manual - OmniCore C30 65
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the controller with vertical mounting kit [3002-2]
Continued
To Next Page
Loading...
