4.3 Cleaning activities
4.3.1 Cleaning of the controller cabinet
Required equipment
NoteEquipment, etc.
ESD protectedVacuum cleaner
Internal cleaning
Clean the cabinet interior with an ESD protected vacuum cleaner, if necessary.
Cleaning considerations
This section specifies some special considerations when cleaning the controller.
• Always use ESD protection.
• Always use cleaning equipment as specified above. Any other cleaning
equipment may shorten the life of paint work, rust inhibitors, signs, or labels.
• Always make sure that all protective covers are fitted to the controller before
cleaning.
• Never remove any covers or other protective devices when cleaning the
outside of the controller.
• Never use compressed air or spray with a high pressure cleaner.
• Never leave the door open when cleaning the exterior.
Product manual - OmniCore C30 205
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
4 Maintenance
4.3.1 Cleaning of the controller cabinet
To Next Page
Loading...
