ABB OmniCore C30 - Environmental Information

7.2 Environmental information
Introduction
ABB robots contain components in different materials. During decommissioning,
all materials should be dismantled, recycled, or reused responsibly, according to
the relevant laws and industrial standards. Robots or parts that can be reused or
upcycled helps to reduce the usage of natural resources.
Symbol
The following symbol indicates that the product must not be disposed of as common
garbage. Handle each product according to local regulations for the respective
content (see table below).
xx1800000058
Materials used in the product
The table specifies some of the materials in the product and their respective use
throughout the product.
Dispose components properly according to local regulations to prevent health or
environmental hazards.
Example applicationMaterial
Heat sinks on power supplies and drive unitsAluminium
Main computerBatteries, Lithium
ElectronicsBrominated flame retardants
CablesCopper
ElectronicsLead
Cables, connectors, etc.Plastic/rubber
Power supply
i
Silicone
Cabinet structure, plates, screws, etc.Steel
i
Silicone can be used in the manufacturing of the module but is removed by design. However, there
might be a small residue left on delivery.
Continues on next page
564 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
7 Decommissioning
7.2 Environmental information