5.3.3 Replacing the incoming mains connector
Location
The illustration shows the location of the incoming mains connector in the controller.
xx1800000040
Note
To confirm whether this unit is available in your controller, see chapter Overview
of the controller on page 38.
If this unit is not available in your controller, ignore the related procedure to this
unit when you do any maintenance or repair work.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Harness-Mains connection3HAC058827-001Harness Power input single phase
Mating connector for Power inlet3HAC064793-001Connector AC power inlet, M22
PLUG
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 570.
-Standard toolkit
Continues on next page
434 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the incoming mains connector
To Next Page
Loading...
