ABB OmniCore C30 - Page 66

Info/illustrationAction
A
B
xx1800000381
Back hanging bracketA
Torx countersunk screw M4x10 (6
pcs)
Tightening torque: 1.7-1.8 Nm
B
Install the back hanging bracket.4
xx1800001277
Remove the right side cover screws.
Note
The right side is the side with fans.
5
Continues on next page
66 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.3 Mounting the controller with vertical mounting kit [3002-2]
Continued