Removing the robot signal exchange proxy
Note/IllustrationAction
Location of wrist strap button:
xx2000000532
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
1
Pull the cable ties out from the locking
holes.
2
xx1800000488
Remove the screws and lift out the robot
signal exchange proxy.
Note
Avoid colliding with the frame of the
controller.
3
Removing the main computer
Note/IllustrationAction
xx1800000540
Remove the screws holding the main
computer.
1
Continues on next page
Product manual - OmniCore C30 269
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.3.3 Replacing the main computer fan
Continued
To Next Page
Loading...
