Removing the small fan
Note/IllustrationAction
xx1800000479
Remove the screws holding the fan.1
xx1800000480
Push and slide the fan bracket and lift it
out.
2
Disconnect:
• G2.X1-K2.X17
3
Removing the connected services gateway
Note/IllustrationAction
Disconnect:
• K7.X1 - K2.X3
i
• K7.X2 - A2.X5
Note
The connector K7.X2 is locked;
grab the connector, push it in to
release it and then remove the
connector.
1
Continues on next page
Product manual - OmniCore C30 301
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.6 Replacing the connected services gateway
Continued
To Next Page
Loading...
