Collaborative applications
If a robot is intended for a collaborative application, where occasional contact
between the robot and the operator is expected, the safety aspects must still be
addressed. See the product manual for the manipulator.
Verify the safety functions
Before the robot system is put into operation, verify that the safety functions are
working as intended and that any remaining hazards identified in the risk
assessment are mitigated to an acceptable level.
32 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
1 Safety
1.5 Safety during installation and commissioning
Continued
To Next Page
Loading...
