ABB OmniCore C30 - Page 369

Note/IllustrationAction
Removing the controller covers on page 222.Remove the top cover.3
Removing the axis computer from the cabinet
Note/IllustrationAction
Disconnect:
• K6.X11 - A1.X3
• K6.X2 - A2.X9
• K6.X1 - K2.X3.
1
xx1800000472
Remove the screws on the bracket.2
Loosen the screw and disconnect:
• K6.X4, K6.X5 - SMB.
3
Removing the power supply optional
Note/IllustrationAction
Disconnect:
• A1.X7 - T5.X1
1
xx1800000549
Remove the attachment screws and lift
the power supply out.
2
Continues on next page
Product manual - OmniCore C30 369
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.11 Replacing the power supply
Continued