Note/IllustrationAction
xx1800000472
Remove the screws on the bracket.2
Loosen the screw and disconnect:
• K6.X4, K6.X5 - SMB.
3
Removing the manipulator signal connector
Note/IllustrationAction
xx1800000727
Remove the attachment screws on the
cover.
1
Push the manipulator signal connector
into the cabinet.
2
Take the manipulator signal connector
out from the upper side.
3
Refitting the manipulator signal connector
Refitting the manipulator signal connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Continues on next page
Product manual - OmniCore C30 413
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the manipulator signal connector (SMB)
Continued
To Next Page
Loading...
