InformationEquipment
See Standard toolkit for controller on
page 570.
Standard toolkit
Installing the 19" rack mounting kit to the controller
Use this procedure to install the controller in a 19" cabinet.
InformationAction
xx1700001885
Remove the screws on the front panel and
the five feet from the bottom.
1
xx1700001883
Front mounting kitA
Back mounting kitB
Torx pan head screw M4x12 (4 pcs)
Tightening torque: 1.7-1.8 Nm
C
Torx countersunk screw M4x10 (5
pcs)
Tightening torque: 1.7-1.8 Nm
D
Assemble the front and the back mounting
kit.
2
Continues on next page
62 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the controller with 19" rack mounting kit [3002-1]
Continued
To Next Page
Loading...
