Note/illustrationAction
xx2000002354
Hang the FlexPendant holder to the
bracket according to the screws on the
bracket.
1
xx2000002355
Hang the holder with the bracket to the
desired place.
2
Hanging the front part of the FlexPendant holder with screws (Vertically)
Use this procedure to hang the front part of the FlexPendant holder to the desired
place.
Note/illustrationAction
xx2000002356
Remove the four screws.1
Separate the rear part from the FlexPend-
ant holder.
2
Clean the surface and make sure it is dry.3
Continues on next page
Product manual - OmniCore C30 79
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.6 Mounting the FlexPendant holder
Continued
To Next Page
Loading...
