Parameters 57
4
Parameters
This chapter describes the parameters of the inverter. The parameters are either editable
or read-only. The editable parameters can be used to change the inverter settings and
they are saved periodically to permanent memory.
The read-only parameters (actual values) can be used to view the inverter status. An
actual value is the result of a measurement or calculation by the inverter, or it contains
status information.
Terms and abbreviations
Term Definition
Bit list Bit list
Data Data parameter
Default Default value for an editable parameter.
FbEq16b (This terms is used in the table Parameter listing (page 61) on the same row as the parameter
range, or for each selection)
16-bit fieldbus equivalent: The scaling between the value shown on the control unit and the
integer used in fieldbus communication when a 16-bit value is selected.
A dash (-) indicates that the parameter is not accessible in 16-bit format.
FbEq32b (This terms is used in the table Parameter listing (page 61) on the same row as the parameter
range, or for each selection)
32-bit fieldbus equivalent: The scaling between the value shown on the control unit and the
integer used in fieldbus communication when a 32-bit value is selected.
List Selection list.
No. Parameter number.
Other The value is taken from another parameter.
Choosing “Other” Shows a parameter list in which the user can specify the source parameter.