ABB RET670 - Page 780

Name Values (Range) Unit Step Default Description
V2LimHys 0.000 - 100.000 % 0.001 5.000 Hysteresis value in % of range and is
common for all limits
V2AngDbRepInt 1 - 300 Type 1 10 Cycl: Report interval (s), Db: In % of range,
Int Db: In %s
V2AngMin -180.000 - 180.000 Deg 0.001 -180.000 Minimum value
V2AngMax -180.000 - 180.000 Deg 0.001 180.000 Maximum value
V2AngRepTyp Cyclic
Dead band
Int deadband
- - Cyclic Reporting type
UAmpPreComp5 -10.000 - 10.000 % 0.001 0.000 Amplitude factor to pre-calibrate voltage at
5% of Ir
UAmpPreComp30 -10.000 - 10.000 % 0.001 0.000 Amplitude factor to pre-calibrate voltage at
30% of Ir
UAmpPreComp100 -10.000 - 10.000 % 0.001 0.000 Amplitude factor to pre-calibrate voltage at
100% of Ir
Table 226: VMSQI Non group settings (advanced)
Name Values (Range) Unit Step Default Description
3V0ZeroDb 0 - 100000 m% 1 0 Zero point clamping in 0.001% of range
3V0HiHiLim 0.000 -
10000000000.000
V 0.001 260000.000 High High limit (physical value)
3V0HiLim 0.000 -
10000000000.000
V 0.001 240000.000 High limit (physical value)
3V0LowLim 0.000 -
10000000000.000
V 0.001 220000.000 Low limit (physical value)
3V0LowLowLim 0.000 -
10000000000.000
V 0.001 200000.000 Low Low limit (physical value)
V1ZeroDb 0 - 100000 m% 1 0 Zero point clamping in 0.001% of range
V1HiHiLim 0.000 -
10000000000.000
V 0.001 260000.000 High High limit (physical value)
V1HiLim 0.000 -
10000000000.000
V 0.001 240000.000 High limit (physical value)
V1LowLim 0.000 -
10000000000.000
V 0.001 220000.000 Low limit (physical value)
V1LowLowLim 0.000 -
10000000000.000
V 0.001 200000.000 Low Low limit (physical value)
V1AngZeroDb 0 - 100000 m% 1 0 Zero point clamping in 0.001% of range
V1AngMin -180.000 - 180.000 Deg 0.001 -180.000 Minimum value
V1AngMax -180.000 - 180.000 Deg 0.001 180.000 Maximum value
V1AngRepTyp Cyclic
Dead band
Int deadband
- - Cyclic Reporting type
Table continues on next page
Section 3 1MRK504116-UUS C
IED application
774
Application manual