ABB RET670 - Page 800

Name Values (Range) Unit Step Default Description
Operation03 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel03 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 3
IndicationMa03 Hide
Show
- - Hide Indication mask for binary channel 3
SetLED03 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 3
Operation04 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel04 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 4
IndicationMa04 Hide
Show
- - Hide Indication mask for binary channel 4
SetLED04 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 4
Operation05 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel05 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 5
IndicationMa05 Hide
Show
- - Hide Indication mask for binary channel 5
SetLED05 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 5
Operation06 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel06 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 6
IndicationMa06 Hide
Show
- - Hide Indication mask for binary channel 6
SetLED06 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 6
Operation07 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel07 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 7
IndicationMa07 Hide
Show
- - Hide Indication mask for binary channel 7
SetLED07 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 7
Operation08 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel08 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 8
Table continues on next page
Section 3 1MRK504116-UUS C
IED application
794
Application manual