ABB RET670 - Page 801

Name Values (Range) Unit Step Default Description
IndicationMa08 Hide
Show
- - Hide Indication mask for binary channel 8
SetLED08 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 8
Operation09 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel09 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 9
IndicationMa09 Hide
Show
- - Hide Indication mask for binary channel 9
SetLED09 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 9
Operation10 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel10 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 10
IndicationMa10 Hide
Show
- - Hide Indication mask for binary channel 10
SetLED10 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 10
Operation11 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel11 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 11
IndicationMa11 Hide
Show
- - Hide Indication mask for binary channel 11
SetLED11 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 11
Operation12 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel12 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 12
IndicationMa12 Hide
Show
- - Hide Indication mask for binary channel 12
SetLED12 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary input 12
Operation13 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel13 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 13
IndicationMa13 Hide
Show
- - Hide Indication mask for binary channel 13
SetLED13 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 13
Table continues on next page
1MRK504116-UUS C Section 3
IED application
795
Application manual