ABB RET670 - Page 802

Name Values (Range) Unit Step Default Description
Operation14 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel14 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 14
IndicationMa14 Hide
Show
- - Hide Indication mask for binary channel 14
SetLED14 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 14
Operation15 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel15 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 15
IndicationMa15 Hide
Show
- - Hide Indication mask for binary channel 15
SetLED15 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 15
Operation16 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel16 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 16
IndicationMa16 Hide
Show
- - Hide Indication mask for binary channel 16
SetLED16 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 16
FUNT1 0 - 255 FunT 1 0 Function type for binary channel 1 (IEC
-60870-5-103)
FUNT2 0 - 255 FunT 1 0 Function type for binary channel 2 (IEC
-60870-5-103)
FUNT3 0 - 255 FunT 1 0 Function type for binary channel 3 (IEC
-60870-5-103)
FUNT4 0 - 255 FunT 1 0 Function type for binary channel 4 (IEC
-60870-5-103)
FUNT5 0 - 255 FunT 1 0 Function type for binary channel 5 (IEC
-60870-5-103)
FUNT6 0 - 255 FunT 1 0 Function type for binary channel 6 (IEC
-60870-5-103)
FUNT7 0 - 255 FunT 1 0 Function type for binary channel 7 (IEC
-60870-5-103)
FUNT8 0 - 255 FunT 1 0 Function type for binary channel 8 (IEC
-60870-5-103)
FUNT9 0 - 255 FunT 1 0 Function type for binary channel 9 (IEC
-60870-5-103)
FUNT10 0 - 255 FunT 1 0 Function type for binary channel 10 (IEC
-60870-5-103)
Table continues on next page
Section 3 1MRK504116-UUS C
IED application
796
Application manual