Accu-Chek Mobile User Manual

179
Checking the meter 7
3 Twist the cap off the applicator. Be careful not to
squeeze the applicator too hard while doing this so
as to not lose any control solution.
4 Hold the applicator at a slight angle with the brush
pointing downwards.
5 Squeeze the applicator gently until you see a small
drop appear at the end of the brush.
6 Then stop squeezing.
The drop will then be absorbed back into the brush.
The brush is now ready to use.
You can hold the meter in your hand or lay it down
while you apply control solution to the test area.
Do not hold the meter with the test area pointing
upwards. If you hold the meter with the test area
pointing upwards, control solution could enter
the meter and soil it.

Accu-Chek Mobile Specifications

General

Measurement Technology	Photometric
Sample Type	Capillary whole blood
Sample Size	0.3 µL
Test Time	5 seconds
Battery Type	2 AAA batteries
Connectivity	USB
Dimensions	121 x 63 x 20 mm
Weight	129 g (with batteries)
Display	LCD
Memory Capacity	2000 results
Measuring Range	0.6 - 33.3 mmol/L
Operating Temperature	10 - 40°C
Operating Humidity	10 to 90% RH
Hematocrit Range	20 to 70%
Test Strip Technology	No test strips required (uses a test cassette)