ACO 6236 - Page 63

62
3)Start/Data collection/Stop :S/E
6236 PC
＜ Data Contents ＞
【A-weighted】
00/01/05⊔02:15:16⊔F⊔130dB+CR+LF
000h00m10s+CR+LF
LAeq⊔⊔:⊔130.0⊔LA05:⊔130.0+CR+LF
LAE⊔⊔⊔:⊔130.0⊔LA10:⊔130.0+CR+LF
⊔⊔⊔⊔⊔⊔⊔⊔⊔⊔⊔⊔⊔⊔LA50:⊔130.0+CR+LF
Lmin⊔⊔:⊔130.0⊔LA90:⊔130.0+CR+LF
Lmax⊔⊔:⊔130.0⊔LA95:⊔130.0+CR+LF
【C-weighted】
00/01/05⊔02:15:16⊔F⊔130dB+CR+LF
000h00m10s+CR+LF
Lceq⊔⊔:⊔130.0⊔LA05:⊔130.0+CR+LF
Lce⊔⊔⊔:⊔130.0⊔LA10:⊔130.0+CR+LF
Lcpeak:⊔130.0⊔LA50:⊔130.0+CR+LF
Lmin⊔⊔:⊔130.0⊔LA90:⊔130.0+CR+LF
Lmax⊔⊔:⊔130.0⊔LA95:⊔130.0+CR+LF
【Z-weighted】
00/01/05⊔02:15:16⊔F⊔130dB+CR+LF
000h00m10s+CR+LF
Lpeq⊔⊔:⊔130.0⊔LA05:⊔130.0+CR+LF
Lpe⊔⊔⊔:⊔130.0⊔LA10:⊔130.0+CR+LF
Lpeak⊔:⊔130.0⊔LA50:⊔130.0+CR+LF
Lmin⊔⊔:⊔130.0⊔LA90:⊔130.0+CR+LF
Lmax⊔⊔:⊔130.0⊔LA95:⊔130.0+CR+LF
S
s
ret
u
rn
r
D：request data
data forward
Start measurement when “S” is transmitted.
・after pass time of “MeasTime”, return ”r”.
・case of Repeat, ”r” is returned every “MeasTime”.
Even if “D” is not transmitted, “r” is automatically
returned.
※After this, inhibiting any other key access than ”E” command.
Data acquired
＜Case of 10min Repeat measurement＞
When MeasTime is set to 10 min Repeat, “r” is returned
every 10min, so “D” is sent every time and data is
collected.
Stop the measurement when “E” is transmitted.
Case of MeasTime is “＊＊＊”, after “E” is transmitted ,
“e” is returned, so wait 1sec and send “D” to collect
data.
⊔ ：space （20）
+CR ：new line （0D）
+LF ：line feed （0A）