6/6
B 100
Safety instructions
GB 04313 - Edition 03 - March 12
Decontamination – product dismantling
According to the regulations 2002/96/CE about Waste of electrical and
electronical equipments, and 2002/95/CE about Restriction of Hazardous
substances, the manufacturer provides a recycling paid service for the end
of-life of waste electrical and electronic equipment.
Any obligation of the manufacturer to take back such equipment shall
apply only to complete not amended or modified equipment, using adixen
Vacuum Products original spare parts, delivered by adixen Vacuum Products,
containing i.e. all its components and sub-assemblies.
This obligation will not cover the shipping cost to an adixen take back facility.
Before returning the product, fill in the safety form available in appendix of
the operating manual. Attach it to the product before shipping to the service-
repair office closest to you.
Maintenance
(cont.)
The products are designed to avoid subjecting users to heat hazards. Specific
operating conditions can nevertheless exist that require extra caution from
users due to the high temperatures generated (outer surfaces > 70° C):
Wear protective gloves to work on the appliance, especially during
maintenance.
Leak detectors fitted with oil seal roughing pumps.
We advise draining the pump prior to any transport of the equipment.
Always wear gloves and goggles when draining the pumps.
Do not put waste oil down the drain. Have it destroyed by a qualified
company if necessary.
Maintenance must be performed by a skilled maintenance operator trained
in the relevant health and safety aspects (EMC, electrical hazards, chemical
pollution, etc.).
Isolate the product from all energy sources (mains electricity, compressed air,
etc.) before starting work.
Major overhauls must be performed by qualified staff who have received
training from the manufacturer, especially when it comes to handling the
fluids inside the detector (see instructions in operating manual).
Do not eliminate maintenance waste via standard disposal channels. Have it
destroyed by a qualified company if necessary.
adixen Vacuum Products - ASM 310 Operating instructions
To Next Page
Loading...
