Figure 10: Pole mounting assembly
6.2.2.2 Surface mounting
If mounting on a surface, use the 4 x M8 fixing holes as indicated in the 5.2.3 Mechanical Drawings. It is
strongly recommended to use the included shoulder washers to provide a small gap between the GNSS
Compass and the mounting surface. This will help protect against warping or cracking of the unit on slightly
uneven surfaces. Note the shoulder washers will require a nominal 10mm hole in the mounting surface as
shown in Figure 11: Surface mounting shoulder washer.
v2.0 Page 24 04 Nov 2021
GNSS Compass Reference Manual • Installing GNSS Compass
To Next Page
Loading...