MANAGING SWITCH
62
The ensuing table for IGMP Static Groups Status settings are informational only: VLAN ID,
Group IP Address, Member Ports and Modify.
Multicast Groups
To access this page, click L2 Switching > Multicast > IGMP Snooping > Multicast
Groups.
The ensuing table for Multicast Groups settings are informational only: VLAN ID, Group IP
Address, Member Ports, Type and Life (Sec).
Router Ports
To access this page, click L2 Switching > Multicast > IGMP Snooping > Router Ports.
The ensuing table for Router Ports settings are informational only: VLAN ID, Port and
Expiry Time (Sec).
MLD Snooping
The MLD Snooping page allows you to select the snooping status (enable or disable), the
version (v1 or v2) and the enabling/disabling of the report suppression for the MLD querier,
which sends out periodic general MLD queries and are forwarded through all ports in the
VLAN.
MLD Settings
To access this page, click L2 Switching > Multicast > MLD Snooping > MLD Settings.
Figure 4-34. L2 Switching > Multicast > MLD Snooping > MLD Settings
The following table describes the items in the previous figure.
Member Ports Enter the port numbers to associate with the static group.
Add Click Add to add an IGMP group.
Table 4-32. L2 Switching > Multicast > MLD Snooping > MLD Settings
Item Description
MLD Snooping State Select Enable or Disable to setup the MLD Snooping State.
MLD Snooping
Version
Select the querier version (V1 or V2) designated to the MLD Snooping
Version.
Table 4-31. L2 Switching > Multicast > IGMP Snooping > IGMP Static Groups (Continued)
Item Description
To Next Page
Loading...
Need help?
General
