REMOTE OPERATION
5-34
BLANK Blank or unblank display parameters: Carrier Frequency, RF Level,
Modulation Depth and Deviations, and Modulation Frequency
Data type :
None
Allowed suffices : None
Default suffix : None
Examples:
BLANK:ON
BLANK:OFF
BLANK?
Prepares message containing information on the display blanking setting in the
following format:
:BLANK:<state>
where: <state> is program mnemonic indicating whether the blanking is ON
or OFF
Examples:
BLANK:OFF
CONTRAST
Sets the LCD contrast, over a scale of 0 to 255
Data type :
Decimal Numeric Program Data
Allowed suffices :
none
Default suffix :
none
Examples:
CONTRAST 120
CONTRAST?
Prepares message containing information on LCD contrast setting in the
following format:
:CONTRAST <nr1>
Example:
:CONTRAST 78
ELAPSED
:RESET
Reset elapsed operating hours to zero
Data type :
None
Allowed suffices :
None
Default suffix :
None
Example:
ELAPSED:RESET
ELAPSED?
Prepares message containing information on elapsed operating hours since last
reset. Fractional part is in 15 minute intervals (0.25, 0.50, 0.75). Format is as
follows:
<nr2>
Example:
454.50
OPER?
Prepares message containing information on total operating hours. Fractional
part is in 15 minute intervals (0.25, 0.50, 0.75). Format is as follows:
<nr2>
Example:
1453.00
To Next Page
Loading...