117
GUIDANCE
GUIDANCE
GUIDANCE
GUIDANCE/STEERING CONTROL
SETUP
Press: Home button > Setup (wrench) button > GPS button
• Manual Guidance
Select this to perform guidance by lightbar
while manually steering the vehicle.
• OnTrac2/OnTrac2+
For more information, see the OnTrac2
section.
• ParaDyme Steering
For more information, see the ParaDyme
insert.
• Operator Presence Alarm
The Operator Presence Alarm disengages
guidance control if the operator does not
have any interaction with the display for a
specified period of time. Use the drop-
down menu to specify the period of time
before guidance is automatically disengaged.
• Lightbar Settings
For more information, see
“Lightbar Settings” on page 118
.
• Required Differential Correction for Guidance
When un-checked allows guidance to operate without differential correction.
Pressing the Setup (wrench) button on the Guidance Tab opens the guidance system
settings for the selected guidance system.
Note: In order to use guidance with the display, you must have a GPS receiver capable of a GPS output rate
of 5 Hz or more.
Require Differential
Correction for Guidance
Steering
Manual Guidance
Operator Presence Alarm
15 Minutes
TSIP
Receiver
0
GPS/Guidance Setup
Lightbar
Settings
To Next Page
Loading...
Need help?
General
