316 Firmware Version 5.2
MAP SCREEN: FLOW DELAY
When the Map screen is running in a Zoom Detail
view, instantaneous coverage (A) is shown
automatically. However, there is a time lag between
when grain enters the combine through the Header
and is logged by the Flow Sensor in the Clean Grain
Elevator. Because of this time lag, the instantaneous
coverage is shown on the Map screen as a lighter
color than coverage that has been logged (B) by the
display.
REGION SELECTION: OPTIONS SCREEN
Press: Home button > Region button
The Region button, located on the Home screen,
opens the Options screen where you can change or
edit regions, select Automatic Variety Tracking or
Automatic Region Changing.
Note: The Options screen also appears when you create a Field Configuration with the Field Operation
Wizard.
• For more information about Automatic Variety Tracking or Automatic Region Changing, see
“Tracking
Varieties and Changing Regions” on page 316.
TRACKING VARIETIES AND CHANGING REGIONS
You can use the Options screen to enable the display to track varieties that you planted earlier and are
now harvesting. You can also use two types of variety tracking: Automatic Variety Tracking and
Automatic Region Changing.
• Automatic Variety Tracking tracks only varieties; hence the operator must manually change to a new
region.
Note: You can select the Variety Tracking option when you are creating a crop during Harvest Product Setup.
• Automatic Region Changing tracks both varieties and regions, so the display changes the region
automatically.
Region:
<1>
Options
Automatic Variety
Tracking
Automatic Region
Changing
Import Variety
Map
--NONE--
Variety Tracking
<1>
To Next Page
Loading...
Need help?
General
