Ag Leader Technology Integra - Application Settings; Planting Settings

26 Firmware Version 5.2
• Add or import Harvest products.
• Add button
Press to add or import a Product. At the following screen, choose a Product Option: Add
Product, Import Product, or Add Product Mix (if in Application). From here, an on-screen
wizard continues you through each step of the setup process.
• When finished, the new product appears in Product Tab.
• When you highlight the product, information about the product appears on the right side of the screen.
• Specific planting and application product information can be viewed in those respective chapters.
• Rename button
Press to rename the product.
• Setup button
Press to adjust configuration settings.
• Remove button
Press to remove a product.
CAUTION: When you remove a product all regions using that product will also be removed!
Planting Settings
• Edit Info button
Press to edit the following information for the highlighted product in the Product List.
- Manufacturer
• Edit Legend button
Press to change the legend settings listed below.
- Average
- Range Spacing
- Color Scheme
- Ranges
- Reset to Default Legend
For more information, see “Legend Settings” on page 55.
Application Settings
• Edit Info button
Press to edit the following information for the highlighted product in the Product List.
- Product Units
- Manufacturer
- EPA Number
- check box for restricted use pesticides
• Edit Legend button
Press to change the legend settings listed below.
- Average
- Range Spacing