166 Firmware Version 5.2
HYDRAULIC SEED CONTROLLER SETTINGS FOR SPECIFIC
PLANTERS
Note: The settings, provided below, should be a good starting point for controller settings. However, always
take the time to calibrate the seed meters, check for proper seed placement in the field, and make system
setting adjustments as needed. Do not rely solely upon the appearance of the On-Screen map. The on screen
map will not show gaps and overlaps caused by incorrect GPS Offsets or AutoSwath Look-Ahead settings.
Planter brand
Control Valve Configuration
PWM Frequency
PWM Gain
Zero Flow Offset
Gear Ratio
Pulses/Rev.
John Deere Planters PWM 175 110 40
2.374 (chain)
2.417
(ProShaft)
360
White Planters PWM 200 90 30 5.5 360
Case IH Planters PWM 100 90 40 6.803 360
To Next Page
Loading...
Need help?
General
