157
PLANTING
CREATE PLANTING CONFIGURATION
You will now be returned to the Operation Configuration Wizard.
14. Select Implement
Select Implement from drop-down menu.
15. Select Planting Method
16. Select Speed Source
Use drop-down menu to select Primary Source, set Backup Source, and configure Auxiliary Channel.
Press Calibrate Speed Sensor to launch the Speed Sensor Calibration Wizard.
17. Enter Configuration Name
A suggested name for the configuration appears. If desired, Press to enter a different name for
your configuration. Press when complete.
The complete configuration should now appear on the Configuration Setup screen and is now able to be
selected when starting a new Field Operation
Note: After completing this configuration, in order for it to become active, you must adjust Seed Monitor
settings in Seed Monitor Setup.
To Next Page
Loading...
Need help?
General
