To Next Page

To Previous Page

180 Firmware Version 5.2

Error Message: “Meter Not Moving - Drive #”

Possible Cause: Either the Seed Meter Calibration failed, or the Seed Meter Prime failed

Solution: Make sure that the tractor’s hydraulic outlet is turned on.

Error Message: “Seed Drive at Maximum RPM Drive #”

Possible Cause: Starting the priming routine when the hydraulic motor is not on

Solution: - Slow the planter unit’s ground speed. - Reduce the Planting Target Rate.

Default Chapter3
- Table of Contents3
General17
- About this Manual17
- Installation23
Setup27
- Configuration27
Management Setup45
- Configuration Selection45
Field Operations63
- Operator Selection63
- Operator Log out64
- Configuration Setup Screen64
- Setup Event65
- External Drive89
  - External Storage Operations89
  - Device Information93
    - Devices93
    - Display Diagnostics93
Settings95
- Equipment Settings95
  - Implement Switch Settings (for Area Logging)95
  - Equipment Configuration Settings for Rate Control96
- Speed Input Settings96
  - Calibrate Distance97
- Auxiliary Input98
- Vehicle Offsets101
Virtual Terminal105
- Common Terminology105
- Auxiliary Assignment107
- VT Alarms and Trouble Codes108
- Task Controller109
- Configuration Setup109
- ISOBUS Settings110
Agfiniti113
- Connecting to Wi-Fi Network113
- Connecting to Agfiniti114
- File Transfer115
Gps121
- Guidance Guidance133
- Pattern Groups145
- Guidance Options146
Ontrac2+153
- Autosteer Setup Screen153
- Vehicle154
- Auto Calibrate157
- System Menu161
- GPS Diagnostics164
- Details165
Tillage167
- Configuration Setup167
  - Load Configuration168
  - Run Configuration168
Planting171
- Create Planting Configuration171
- Rate Control179
Down Force197
- Modes of Operation197
- Create Equipment Configuration197
- Setup down Force Configuration198
- Calibrate Pressure Sensor200
- Down Force Status200
Seed Tube Monitor Module205
- Configuration Setup205
- Seed Monitor Setup206
  - Autoconfig Procedure206
  - Seed Tube Sensor Configuration207
KINZE Planter Monitor Module219
- KINZE Planter Configuration219
Application233
- Liquid Rate Control233
- Miscellaneous260
Injection265
- Battery Power Pin Outs271
  - Direct Injection: Pump Runs Full Speed271
- Digital Pump Speed Pin Outs271
- Analog Speed Pin Outs272
  - Direct Injection: Application Error272
  - Direct Injection: Discharge Flow Sensor Error272
- Discharge Flow Sensor Pin Outs273
  - Direct Injection: Inlet Restriction273
- Vacuum Switch Pin Outs273
Optrx275
- Norac Uc5285
- Strip Till305
Harvest Monitoring/Mapping323
- Display Preparation323
- Vehicle Inspection323
- Create Configuration323
- Configuration Setup323
  - Calibration Sequence323
  - Calibrate Distance324
Appendix343
- System Diagrams Reference343
- Current File Formats343

Brand	Ag Leader Technology
Model	Integra
Category	Monitor
Language	English

Ag Leader Technology Integra User Manual

Table of Contents

Questions and Answers:

Ag Leader Technology Integra Specifications

Related product manuals