246 Firmware Version 5.2
• Zero Flow Offset
Represents the maximum duty cycle that is sent to the control valve without producing any hydraulic flow
from the PWM valve. Using too high of a Zero Flow Offset value can cause the product control system to
not properly control low rates. See the PWM valve manufacturer information for recommended settings.
• Shaft Speed Cal
Calibration number representing the pulses that equal one revolution of the rate control metering system.
• Max Conveyor Speed
Setting determines the maximum RPM of the conveyor that controls product distribution to the application
point. This setting is used when controlling a spinner spreader applicator.
• Fan Speed Cal
Number of pulses that are generated by the sensor during one revolution of the blower fan shaft.
• Max Metering Speed
Setting determines the maximum RPM of the metering shaft that controls product distribution to the
application point. This setting is used when controlling a granular strip-till toolbar.
• Min Speed
Setting represents the desired minimum speed of the blower fan. An alarm will sound if the blower fan
speed falls below this value.
• Max Speed
Setting represents the desired maximum speed of the blower fan. An alarm will sound if the blower fan
speed exceeds this value.
• Low Fan Speed Shutoff
When selected, granular product application of a strip-till toolbar will be shut off if fan speed drops below
the Min Speed setting.
• Rate Threshold
Percentage difference between the Actual Rate and the Target Rate when the Rate Not Responding
Message is displayed on the Run screen.
To Next Page
Loading...
Need help?
General
